Welcome! Log In Create A New Profile

repetier,ramps,dual extruder,dual fan

Posted by woo

woo

repetier,ramps,dual extruder,dual fan
May 26, 2014 02:23PM

Registered: 11 years ago
Posts: 248

Hello,i have dual extruder with ramps1.4 and i have buyed expansion board for 2 additional fans for ramps,idea is to have one fan for one extruder. How to set this up in repetier?

On marlin is all done when chosen motherboard 34. Wil it work if i copy pins settings to repetier? Thank you

Reply Quote

repetier

Re: repetier,ramps,dual extruder,dual fan
May 27, 2014 03:39AM

Registered: 12 years ago
Posts: 2,705

No, you can not copy marlin pin settings. All you need to do is select the pin numbers of the expansion board for your fan functions. You can look them up in marlin pin.h if you know where they are there. I think it was 4 and 5 for ramps 1.4.

Repetier-Software - the home of Repetier-Host (Windows, Linux and Mac OS X) and Repetier-Firmware.
Repetier-Server - the solution to control your printer from everywhere.
Visit us on Facebook and Twitter!