Welcome! Log In Create A New Profile

Getting holes and dimensions correct

amr_dwarf

Getting holes and dimensions correct
February 20, 2014 02:20AM

Registered: 10 years ago
Posts: 48

Using Slic3r and Pronterface to run my Mendel90 dibond.

Holes in prints always turns out a bit smaller then in the cad model.
Inside measurments of geometries are allways a bot to small.

What settings should I look at, how do I calibrate to get this right?

Cheers
Dwarf

Reply Quote

neildarlow

Re: Getting holes and dimensions correct
February 20, 2014 06:15AM

Registered: 10 years ago
Posts: 541

Take a look at nophead's post on Polyholes here.

Regards,
Neil Darlow

I try to write with consideration for all nationalities. Please let me know if something is unclear.
Printing with Mendel90 from fedora 25 using Cura, FreeCAD, MeshLab, OpenSCAD, Skeinforge and Slic3r tools.