Weird z-height variance May 01, 2015 06:40AM |
Registered: 11 years ago Posts: 369 |
Re: Weird z-height variance May 01, 2015 12:25PM |
Registered: 10 years ago Posts: 541 |
Re: Weird z-height variance May 02, 2015 04:50PM |
Registered: 9 years ago Posts: 34 |
Quote
neildarlow
As an aside, I have noticed that my initial ooze-free startup characteristic has changed recently. I used to get a small blob followed by a thin line before the fat wipe line was printed. Now I seem to get the small blob followed by nothing and a partial fat wipe line. This seems odd because,like you, I have not changed my start/end sequences.
Regards,
Neil Darlow
Re: Weird z-height variance July 08, 2015 12:54PM |
Registered: 11 years ago Posts: 369 |
Re: Weird z-height variance July 08, 2015 01:23PM |
Registered: 10 years ago Posts: 541 |
Re: Weird z-height variance July 08, 2015 02:59PM |
Admin Registered: 17 years ago Posts: 7,879 |
Quote
The first layer height only reverts to being ‘too thick’ if I leave the printer off for an extended period – a week or more as has often been the case recently.
Quote
If I turn off the printer and repeat this tomorrow then I suspect I will get exactly the same results. Whatever the problem is, it resets overnight.
Re: Weird z-height variance July 08, 2015 07:26PM |
Registered: 11 years ago Posts: 369 |
Re: Weird z-height variance July 09, 2015 03:47PM |
Registered: 9 years ago Posts: 34 |
Re: Weird z-height variance July 10, 2015 04:55AM |
Registered: 11 years ago Posts: 369 |
Re: Weird z-height variance July 10, 2015 05:24PM |
Registered: 9 years ago Posts: 34 |
Re: Weird z-height variance July 12, 2015 04:50AM |
Registered: 11 years ago Posts: 369 |