Welcome! Log In Create A New Profile

Advanced

Paneldue and Setbed

Posted by smoothboy 
Forum List Message List New Topic
smoothboy
Paneldue and Setbed
May 20, 2015 02:45AM
I've assembled the Paneldue on my Ormerod 1 and all is working properly, but I can't figure out how to send Setbed. The Panel Due firmware is 1.07
Could you please help me?
Thank you! smiling smiley

Rick.
Reply Quote
ormerod168
Re: Paneldue and Setbed
May 20, 2015 03:28AM
You could make a Set Comp file and place it in the SD-Cards macros folder

    G30 P0 X0 Y0 Z0.0
    G30 P1 X0 Y200 Z0.0
    G30 P2 X200 Y200 Z0.0
    G30 P3 X200 Y0 Z0.0
    G30 P4 X100 Y100 Z0.08 S

and Reset Comp:

    M561

Erik
Reply Quote
dc42
Re: Paneldue and Setbed
May 20, 2015 05:47AM
That's right, use a macro file either to duplicate your setbed file, or to print your setbed file.


Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Reply Quote
smoothboy
Re: Paneldue and Setbed
May 20, 2015 08:23AM
Yes thank you! It is perfectly running! spinning smiley sticking its tongue out
Reply Quote
dc42
Re: Paneldue and Setbed
May 20, 2015 09:32AM
I'm glad you got it working. The next PanelDue firmware revision will have a bed compensation/delta calibration button next to the homing button(s), which will run G32. As G32 now runs bed.g if it exists, you can use that file to do your complete setbed sequence.


Large delta printer [miscsolutions.wordpress.com], E3D tool changer, Robotdigg SCARA printer, Crane Quad and Ormerod

Disclosure: I design Duet electronics and work on RepRapFirmware, [duet3d.com].
Reply Quote
Newer Topic Older Topic
Sorry, only registered users may post in this forum.

Click here to login