I have been fairly pleased with the print quality from my core. I have done quite a bit of work to tighten things up mechanically and just switched over to the Alternate Z Axis from andreasL. One thing I haven't even touched are the slicer (or configuration.h) settings for acceleration, speed, jerk, etc. Has anyone tweaked these up for their core and would be willing to share? In the very least it would serve the rest of us as a good jumping off point for our own fine-tuning.

Thanks!

that would be great indeed. Shame on me , i've never had time to play with those parameters , espcially acceleration , jerk.etc.. there must be something to win to adapt to the core's features .. maybe ?

thank you

---

the Smartrap project

[smartfriendz.com]
[www.thingiverse.com]
[reprap.org]
[github.com]
doc assemblage: [reprap.org]
NEW: Forum smartfriendz: [smartraptalk.smartfriendz.com]

Im also qondering about these settings, after getting my Core to a decent point. Im assuming the slicing profiles/firmware available from the SmartrapCore github are pretty close to the mark, but id also like to know any info on improving print quality.