Hi,
I'm a newbe to this. The Prusa Mendel build was easy, very good instructions...It was a blast to build. Getting firmware to load in Arduino 1.0 has not been fun....I have Ramps 1.4 electronics , Nema 17 stepper motors, Arduino 1.0, Windows 7, and downloaded Kliment-Sprinter-e990ed8.
But I cannot get the Sprinter to compile in Arduino. I get errors in the SD tabs section when I try to compile. Anyone have a Sprinter file that was able to compile with Arduino? I really want to get this thing going. I can't get past the firmware load.
Any direction would be most welcome..