Setting vRef - Folger Tech Kossel 2020 w/Autolevel

So Im wrapping up my build and am at the point where I need to set the voltage on x,y,z, and e. In the manual it says to set x, y, and z to .350 and e to .55 I can set x y z fine but I can't get e close at all. The best I can get it .479

Anyone else run into this? I swapped the stepper controllers around and still no joy. How close does e have to be and can I compensate for it in the configure somewhere?

Thanks!
Mike

Edited 1 time(s). Last edit at 04/26/2015 12:37AM by bluesmike.

I was able to get .36 on each of the x,y, and z drivers for Vref, I originally set the Vref for the extruder to .55 and the stepper could not push the filament through and it was recommended to in the other forum topic to set the Vref to .7-.85 and I am now running with it set to 0.75 with good results.