Welcome!
Log In
Create A New Profile
Home
>
Reprappers
> Topic
Advanced
ATX Power Supply
Posted by
adenton
Forum List
Message List
New Topic
adenton
ATX Power Supply
May 27, 2016 10:52PM
Registered: 8 years ago
Posts: 52
Hello,
I am working on the ATX power supply to my RepRap. I have EVGA 500W and there are 2 4-pins CPUs. Should I use one or both of them to get 12V to my RAMPS board?
I've looked at the diagrams that reprap.org provide, but I am doing it a bit differently.
Reply
Quote
ggherbaz
Re: ATX Power Supply
May 28, 2016 12:43AM
Registered: 10 years ago
Posts: 1,401
Both will be best, since ramps uses two power connectors you can connect one to each of ramps board.
Be sure that both deliver same power, if not use the most powerful for your heated bed.
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login