anyone know what is going in here?

21:12:04.890 : echo:Advanced variables: S=Min feedrate (mm/s), T=Min travel feedrate (mm/s), B=minimum segment time (ms), X=maximum XY jerk (mm/s), Z=maximum Z jerk (mm/s), E=maximum E jerk (mm/s)
21:12:04.894 : echo: M205 S0.00 T0.00 B20000 X20.00 Y20.00 Z0.40 E5.00
21:12:04.894 : echo:Home offset (mm)
21:12:04.894 : echo: M206 X0.00 Y0.00 Z0.00
21:12:04.898 : echo:Material heatup parameters:
21:12:04.898 : echo: M145 S0 H180 B70 F0
21:12:04.898 : M145 S1 H240 B110 F0
21:12:04.898 : echoID settings:
21:12:04.902 : echo: M301 P22.20 I1.08 D114.00
21:12:04.902 : echo:Filament settings: Disabled
21:12:04.902 : echo: M200 D3.00
21:12:04.902 : echo: M200 D0
21:12:05.356 : Printer reset detected - initalizing
21:12:05.356 : start


i cant print the object when i click on print with the software " repetier host " choose sli3ce , and the software heat up my heat head nozle ( with thermsitor + step motor ) and after when the nozzle hit the temp 200 degree C and the software wont allow me to print or sometimes the x , y , z run everywhere dont know how to stop either me push on the estop x , y they wont stop , only click on emergency stop on the repetier host software , anyone have any idea how to fix it? My board is RAMPS 1.4 Arduino Mega 2560

Can you post the gcode file for the part you are trying to print, or the first 20 lines of gcode

i have the words file , please help me fix this problem , its may be i set the Home is incorrect? Or something wrong with my firmware or software?

Edited 1 time(s). Last edit at 03/12/2017 09:25AM by stevenkw1.

Your start g-code looks fine, so when does the problem happen. Ill step through the start code and you tell me where the issue is

Home all axes
lift z axis 5mm
Wait for the hotend to reach 200°C
lower Z axis to 0.35
retract some filament
move to first print point

Also when you say "wont allow to print" what exactly happens? sometimes it takes time for the nozzle to be primed and start to flow, adding a perimeter will make sure filament is flowing before it starts the print

"Axis run everywhere" again cant tell much from this, take your time and explain exactly what happens