Welcome! Log In Create A New Profile


BLtouch Y axis home help

Posted by imfineyourefine 
BLtouch Y axis home help
September 28, 2018 03:25PM

I've got my Bltouch setup and working, however I need help telling Marlin to home the y axis further up. Right now I have my z probe mounted about 50 mm in front of the hot end, when I home x and y the bed goes all the way back to 0 but when the z axis lowers the probe the bed is too far back so there's nothing for the probe to contact.

How do I configure Marlin so the bed doesn't start all the way back?
Re: BLtouch Y axis home help
September 29, 2018 03:13PM
In config.h enable Z safe homing so the nozzle moves to the centre of the bed to home Z

//#define Z_SAFE_HOMING <<<remove the //
Re: BLtouch Y axis home help
October 01, 2018 09:17AM
That did it!

Sorry, only registered users may post in this forum.

Click here to login