Forum List
Message List
New Topic
Dennis Mc
N1 T0*59
February 08, 2015 10:41AM
Registered: 9 years ago
Posts: 19
Hello,
Occasionally I get the following message during a print "Unknown commnd: N1 T0*59". Sometimes everything locks up requiring reboot of the Arduino board, sometimes the print continues to the end.
Does anyone know what this means?
Thanks, Dennis.
Reply
Quote
MindRealm
Re: N1 T0*59
February 08, 2015 06:24PM
Registered: 9 years ago
Posts: 329
Take a look at the G-Code in a text editor. You have a bad command being passed to the printer.
On line 1 in your G-Code, T0 is being sent as an unknown command or variable. (the *59 is a checksum value)
-David
Find me online at:
Thingiverse
Instructables.com
LinkedIn
Facebook
Check out my FolgerTech Prusa i3 (plexi) at
MindRealm.net
Reply
Quote
Newer Topic
Older Topic
Print View
RSS
Sorry, only registered users may post in this forum.
Click here to login