[SOLVED] Esteps fail with bulldog lite.

After a week of wanting to smash my printer I have it up and running again but for one issue.

Running Triffid hunters calibration test I am coming a cropper with the esteps calibration.

The i'm running it with the hot end but the extruder is clicking away and only extruding 95 mm instead of 100 mm (or near enough),
Is this down to the pully not having enough pressure on it or back pressure from trying to shove filament through a 0.3 mm nozzle?

SOLVED IT, printrun wasn't calibrated !

Edited 1 time(s). Last edit at 06/21/2015 10:02AM by GRAYWOLF.

Quote
GRAYWOLF
After a week of wanting to smash my printer I have it up and running again but for one issue.

Running Triffid hunters calibration test I am coming a cropper with the esteps calibration.

The i'm running it with the hot end but the extruder is clicking away and only extruding 95 mm instead of 100 mm (or near enough),
Is this down to the pully not having enough pressure on it or back pressure from trying to shove filament through a 0.3 mm nozzle?

clicking during extruding? that is probably due to high pressure, try to reduce it

Solved it, Cura was configured, but printrun wasnt set up for the printer.