Hi, could some kind sole please point me in the right direction.... As I'm lost.
I have down loaded Arduino and installed it, and downloaded the Marlin Firmware, but it's the basic bit of getting Marlin in to the Arduino IDE I need help with.
As in.... Which file do I open that loads in the rest of the files....
Also, the Ramps board I'm using already has a working copy of the Firmware onboard....
Can I back it up on to the Laptop here?
It's been along time since I did any programming, so bare with me please... The Grey Cells have gone White over the years.....lol
Kim..
Please send me a PM if you have suggestions, or problems with Big Blue 360.
I won't see comments in threads, as I move around to much.
Working Link to Big Blue 360 Complete