Welcome! Log In Create A New Profile

P802 Prusa Zonestar

Posted by nkuck

nkuck

P802 Prusa Zonestar
April 17, 2016 11:12AM

Registered: 8 years ago
Posts: 61

I am wanting to replace the controller that came with this printer but am reluctant to do the uploading of the firmware and bootloader. I am generally familiar with Arduinos, but not sure if there are any special tricks required in uploading a new firmware, and if I need to do anything regarding installing a new bootloader? Anyone have any advice or support? Thanks.

Reply Quote

Hally

Re: P802 Prusa Zonestar
June 07, 2016 03:40AM

Registered: 7 years ago
Posts: 15

Hi Friend,
If the LED will flash several times, it indicates the bootloader is OK, you don't need burn bootloader again.

If you need more supporting, please send an email to: zonestar@163.com

Hally Zhong
***********************************
Shenzhen Zonestar Innovation Tenchnology Co., Ltd.
E-mail: zonestar@163.com