So I have an Anycubic delta with Trigorilla board (REPRAP 1.4).
I have configured anf flashed latest Marlin bugfix-2.0 (8 Jan 2019). All seems to be working fine.
I then enabled LIN_ADVANCE and problems started. No matter what K value I set (even 0), my extruder driver switches off (releases motor) on first combined move (move with extrusion).
Tried both in S3D and Cura.
To reproduce:
G1 E5 --> extrudes fine
G92 E0
G1 Z-1 E5 F300 --> E motor suddenly jumps around and stops.
I am using TMC2100 drives and have noticed that they shut down when multiple steps are skipped. So probably this is happening with extruder as well.
I have attached my config files.
What do I do next?
