I added a BLtouch clone probe to my CR-10 printer running Marlin 1.1.9 and now I have some issues after bed leveling. After my G29 bed leveling command finishes, my printer head won't move on the Y axis, and will only go to X95 if I send the command G0 X0. I've also noticed that if I rehome the print head I can move Y in the negative direction, but it I try to move at all in the positive direction it tries too move to Y500 which is off of my bed. Also if I try to print something, even if Octoprint shows the Gcode layout in the center of the bed, it tries to print at the maximum Y position in the middle of the X. If anybody has some suggestions to try out, I would really appreciate it.
