Just built an MPCNC and this is my first experience with Marlin 2.0. Issue I'm having is that I set x and y bed size in the firmware and the travel limits after homing were set to those variables, however I can still jog the machine past those limits.
UPDATE: I just found the software endstop settings. Everything is working now. I thought setting the "max travel limits after homing" values was good enough, didn't realize I then had to enable them in the next section for them to mean anything.
Edited 2 time(s). Last edit at 04/10/2019 06:25PM by motownlucas.