Hello! This is my first post, sorry in advance for any rule violations.
I wanted to stretch the boundaries of my X-axis from 200 to 250. Pulled the git repo, checked out the version that my machine was currently using, made tweaks to the configuration.h file to the best of my knowledge, and flashed the atmega. Now the printer has all kinds of problems, including having both positive and negative motion commands send the head in the same direction (positive). I set the limits back to the original and am just trying to get back to where I started.
Using Repetier-Host v2.1.5 to control a Prusia i3 V2 printer on Marlin v1.1.6, using RAMPS 1.4 board. (tried with both 1.3 and 1.4 motherboard defines)
Any help would be appreciated. Thanks!
Current configuration.h file attached.
