Marlin managing current differently in 2.0.x??

I upgraded from Marlin 1.9.x to 2.0.7.
- I am using an Einsy Rambo with integrated TMC2130 drivers. I literally used the same currents from the 1.9.x version on the 2.0.7 and the motors barely have strenght to move.
- How is this possible? Is the new marlin managing current in a different way?

I am using stealthchop on both versions.

XYZ Current 700
E0 Current 800

Those values are the same on both 1.9.x versions and 2.0.7.

Cheers,
JJ

Are you in the correct Configuration_adv.h section?

there are many that look similar for various types of tmc's

You want HAS_TRINAMIC_CONFIG section.

yes of course, I am on that section. Its weird because I have to set the current higher for every driver yet the motors run colder than on 1.9.x.....