Is there no alarm when the gcode XYZ values are outside the machines travel?
I just had about 7-8 mm of the model clipped off on the back side. The Printer posted no error message or alarm. Octopi posted no errors or alarms.
I didn't notice it because the section was printed while I was not baby sitting it. Once it was past it, it wasn't noticeable until removed from the bed.
I am a retired machinist and have never seen a CNC machine tool ignore an over travel and just continue.
Is there a G-code that can turn on the alarm or is there even one?
Its a Ender 3 Pro running Marlin 2.0.7.2
Edited 1 time(s). Last edit at 08/08/2021 12:48PM by Coffee_.