G29 returning error ? (L,R,F,
out of bounds on Delta Printer
Posted by Syzeryuino
|
G29 returning error ? (L,R,F, out of bounds on Delta Printer November 25, 2021 01:46PM |
I have An Anycubic Kossel Pulley with a trigorilla board.G29 will always give the following error:"? (L,R,F, out of bounds. I'm running marlin 1.1.9 and everything works except the bed levelling, and without it everytime I do auto calibration (G33) it always ignores the probe-z offset and the printer always crashes I've been searching for solutions but couldn't find my solution pls help.
my pastebin is
Configuration.h = [pastebin.com]
Configuration_adv.h = [pastebin.com]
out of bounds. I'm running marlin 1.1.9 and everything works except the bed levelling, and without it everytime I do auto calibration (G33) it always ignores the probe-z offset and the printer always crashes I've been searching for solutions but couldn't find my solution pls help.my pastebin is
Configuration.h = [pastebin.com]
Configuration_adv.h = [pastebin.com]
Sorry, only registered users may post in this forum.