Hello, i have dual y motors that run independently of each other and both have their own end stops.
i did the following:
#define Y_DUAL_ENDSTOPS
#if ENABLED(Y_DUAL_ENDSTOPS)
#define Y2_USE_ENDSTOP _E1DIAG_
#define Y2_ENDSTOP_ADJUSTMENT 0
#endif
#endif
When i do an m119 everything is neatly "open" except y2 "triggers"
i have attached configuration files.
vriendelijk bedankt alvast voor het meedenken.
groet Edwin
Edited 2 time(s). Last edit at 12/27/2023 06:28PM by edensan.
