BLTouch setup FT5
Posted by cozmicray
|
BLTouch setup FT5 July 14, 2018 03:40PM |
Folgertech FT5
Mks Gen v1.4
Marlin 10-7 Bugfix
Repitier-Host
bed X 295, Y 295
BLTouch classic mounted 54mm to left of nozzle
(0,0 on FT5 is at right rear)
Only probe offset is the Y 54mm
X, Y, Z homing works well (BLTouch is Z endstop sensor)
UBL leveling
Probe is sent off of the bed (both X, Y)
Where in Marlin are the Probe limits for UBL located
What else should I do for UBL set up?
Mks Gen v1.4
Marlin 10-7 Bugfix
Repitier-Host
bed X 295, Y 295
BLTouch classic mounted 54mm to left of nozzle
(0,0 on FT5 is at right rear)
Only probe offset is the Y 54mm
X, Y, Z homing works well (BLTouch is Z endstop sensor)
UBL leveling
Probe is sent off of the bed (both X, Y)
Where in Marlin are the Probe limits for UBL located
What else should I do for UBL set up?
Sorry, only registered users may post in this forum.