SKR 1.3 Marlin 2.0 CNC no extruder ... unable to run

Hi,

i want to use this setup for my mpcnc, so i set #define EXTRUDERS 0 but now it is no longer compiling

In file included from Marlin\src\Marlin.cpp:35:0:
Marlin\src\module/motion.h:128:71: error: too many initializers for 'const float [0]'
   constexpr float hotend_offset[XYZ][HOTENDS] = { { 0 }, { 0 }, { 0 } };

i am not able to figure out what i did wrong.
an i am also not able to find a guide how to configure marlin 2.0 for CNC :/

in ideas or hints?

br
Mantus

The best information I can give you is V1 Engineering they have everything from STL files to Build and Firmware setup.

I built my MPCNC from this site, though have only done a few sketches, as I am still waiting on the last few modifications and time to install and then will preform my first live CNC Cut.


I have done a few sample Air cuts, am waiting to install the final modifications before I actually cut a wooden model.


Edited 4 time(s). Last edit at 11/11/2019 07:49AM by Roberts_Clif.

---

Computer Programmer / Electronics Technician

I set EXTRUDERS 0 on my skr 1.3 it compiled without issue.

need to at least post your configuration.h ...

Edited 1 time(s). Last edit at 11/10/2019 08:57PM by Dust.

Quote
mantus
... i want to use this setup for my mpcnc...

Perhaps you're interested: MPCNC with SKR 1.3/TFT35

Custum Marlin 2 for MPCNC-TFT35-V2.0
Custum CNC Firmware for BTT TFT35 V2.0

And another Marlin Branch for MPCNC-SKR 1.3
Marlin tree mpcnc-skr13

Edited 1 time(s). Last edit at 12/29/2019 10:33AM by bianchifan.

Quote
bianchifan

Quote
mantus
... i want to use this setup for my mpcnc...

Perhaps you're interested: MPCNC with SKR 1.3/TFT35

Custum Marlin 2 for MPCNC-TFT35-V2.0
Custum CNC Firmware for BTT TFT35 V2.0

And another Marlin Branch for MPCNC-SKR 1.3
Marlin tree mpcnc-skr13

Thank You

Will place these in my Marlin Save Folder.

---

Computer Programmer / Electronics Technician