Hello all,
I am working on v2 of the Marlin firmware. I am not sure if this is a bug in the firmware or if I have a settings issue.
What is happening is that each time I reboot the printer, I have a message that appears that says "Flex-glass service!" Now, in a certain case, this is required because I did enable the print counters and this is one of the service items that I want to monitor.
When I reset the service interval from the menu screen, the message goes away until I reboot the printer and then it appears again.
I have looked through the source code and I cannot seem to find anything wrong. Has anyone else ran into this issue before?
I believe that I have an EEPROM issue because the message disappears not only when I reset the specific service interval but also any of the other 2.
Please let me know your thoughts.
