Hi,
Ihave upgraded the version of MArlin to 2.03.9 and I can't read my SD card from the LCD.
Below are the different options I have selected :
#define SDSUPPORT
#define REPRAP_DISCOUNT_FULL_GRAPHIC_SMART_CONTROLLER
#define SDCARD_CONNECTION LCD
If I swich on my printer without a card in the LCD slot, the lign "No Media" shows up and if I insert a SDcard, it is not detected, so I have to switch off and on again.
With the previous version of Marlin, I could preheat my printer without any SDcard inserted, and it was detected instantaneously (or so).
I surely miss something, but what ?
Please help
Regards
Thierry
Edited 1 time(s). Last edit at 08/22/2021 03:50PM by Thierry72.