Welcome! Log In Create A New Profile


Manually Adjusting H parameter?

Posted by clearlynotstefan 
Manually Adjusting H parameter?
February 09, 2017 02:35AM
So I'm able to technically print across all of my 300mm bed, but I'm noticing in a particular spot my first layer is a little too squished. I'm using H parameters in my bed.g with the IR probe. If I wanted to manually tinker with the H parameter, which way should I be going on the probe point near the squished spot? Do I make H bigger or smaller to tell it to raise the nozzle a bit more.
Re: Manually Adjusting H parameter?
February 09, 2017 05:22AM
Sorted it, up is up haha.

Let the record show I just printed a 295mm circle with a perfect first layer, no mesh leveling and only s4 factor calibration. After endless struggles the big delta prints!
Sorry, only registered users may post in this forum.

Click here to login