Welcome! Log In Create A New Profile


Smoothie stuttering -- "look-ahead" option?

Posted by StlLooking 
Smoothie stuttering -- "look-ahead" option?
March 10, 2018 01:21PM

Anycubic Delta with latest smoothie firmware.

I am printing a section of 1-1/2" internal Acme thread at 60mm/s and about three times per revolution the Smoothie is pausing/stopping for a fraction of a second and causing a small ooze-blob. Not desirable for a thread. smiling smiley

I tried both Slic3r and Cura latest versions and Cura is much better with the blobs being about once per revolution.

Is there some form of look-ahead setting that I can try to fix this?

Or is this a buffer-clearing/garbage-collection thing of the Smoothie firmware?

The kicker is that when I had the RAMPS+Mega board in before the Smoothie and running at 55mm/s this never happened with either Slicer. Dropping to 55mm/s for the Smoothie makes no difference, I still get the blobs.
Sorry, only registered users may post in this forum.

Click here to login