Hi Jack, in my case it was bad soldering, with patient check for shortcircuit.by spghost - General
i found two pins soldered together with a little tin ball in the ramps board now the lcd is working fine. Thanks everybodyby spghost - General
hereĀ“s my pins.h , its 100% original untouched from last Marlin update, last night i change from the original configuration.h file only this part: //LCD and SD support #define ULTRA_LCD //general LCD support, also 16x2 //#define DOGLCD // Support for SPI LCD 128x64 (Controller ST7565R graphic Display Family) #define SDSUPPORT // Enable SD Card Support in Hardware Console //#define SDSLOW // Useby spghost - General
I made that like 478 times but always the same result. I don't know how to re map the buttons maybe is wrong for my lcd i googleit a lot and in some old forum i read that theres a conflict with new version of marlin and that lcd one of the pins now is used to fan control but im not sure maybe its just broken. Sorry my english its very bad i hope you can understandby spghost - General
Mmmm i don't think so because when i press the encoder the buzzer sounds weirdby spghost - General
I have a problem with my The RepRapDiscount Smart Controller (white PC no matter what i do in the firmware i always end with the screen changing continuously between info screen and menu (Picture 1 and 2) plus the beep beep beep... i read in other post im not the only one. Suggestions? im using Arduino 1.5.6-r2 in windows 8.1 64bits heres my Configuration.h #ifndef CONFIGURATION_H #define CONFby spghost - General