Hi everybody i try to print my first big part by SD card and after almost 50% from job the printer decide to stop ,i can't believe!!! why is it happened ? how can i know where is it stop and how can i start it from that point or even to cut the model and to start the second part and after that to combine them by glue? but than i need to know exactly where to start the second part . please adviceby shaip - General
thank you . i change it and now the hot end fan always run and the second one connected to the board. its look good , but i am still have some problems , there are some parts that success only by using cura and some part only by using slic3r one of the problem is that i don't get good adhesion between the external wall to the infill .by shaip - General
hi sorry i don't have driver , i bought the printer and driver was already inside the board the led in the bed is the only one that i have and its start only after start warming !by shaip - General
hi thanks for your quickly response 1. when you said fan for "hot end" do you mean the number 1 or number 2 ? (in the attached photo) 2 no i'm not using 2 STL files combined. this is the same file (printed with fans "on" (both of them) during all printing if it make you sense) 3. i'm printing with pla and i don't get good adhesion in the big part (if compare it to printing small part). its lookby shaip - General
hi guys I'm new in this world and just bought my prusa i3 before amount i already success with some printing but still have unclear problems and questions: 1. my printer controlled by "melzi" and i read somewhere that the hot head fan should always work so,i need connect it directly to 12V and do not connect it to the "fan" connection on the board. can it be? (currently i added micro switch tby shaip - General