After much searching thinking swearing etc I have now identified the problem. It is an unstable driver in relation to my computer/windows 10 32 bit. After reloading everything all worked fine for about 10 minute then it started to drop the connection to my ardunio. I have used different USB boards different ardunio different RAMPs all have the same problem. So my PC does NOT like Ardunioby sveno - Firmware - experimental, borrowed, and future
As You I have repetier host and Marlin Firmaware. I have searched but I nust have missed the adjustment you metion. Where can I find it??by sveno - Firmware - experimental, borrowed, and future
Why do they run at "normal" speed and power when I run them manualy and at snails pace so slow and no power when I push they Z home button? That is the problem if I was unclear first. Both z drives run the same manualy but at z home they are out of power and speed. That is the reason for out of synch.by sveno - Firmware - experimental, borrowed, and future
Why do they run at "normal" speed and power when I run them manualy and at snails pace so slow and no power when I push they Z home button? That is the problem if I was unclear first. Both z drives run the same manualy but at z home they are out of power and speed. That is the reason for out of synch.by sveno - Firmware - experimental, borrowed, and future
Yes this would work if the problem was torque But as they work 100% correct in all other modes except Z homing then this will not help. Please more ideasby sveno - Firmware - experimental, borrowed, and future
I have a problem with homing on the z axis. When I run the z axis in manual mode speed is as it should be but when I press Z home the speed is almost 0 and the two drives do not run parallell. I have Marlin firmware Mega 2560 R3 Ramps 1.4 and TMC2100 drivers. Switching drivers does not change any thing nor changing to another driver type. The other axis work as they should both in manualby sveno - Firmware - experimental, borrowed, and future
My printer with Mega 2560 Ramps 1.4 stopped working. What did I do? -turned of every thing and removed the DRV 8825 and the jumpers. Mounted a TMC2100 and turned on every thing. Now nothing works. Tried to put back jumpers and remount DRV825 still nothing. Ideas on what has happened. I have a light on the Mega and also on the Ramps but no connection. Before it was on Com 3 but now com 3 isby sveno - General