I have six screws holding the Piezo to the mounting bracket. For some reason I decided to test the probing as I removed each screw. When I removed one of the rear screws the unit worked as expected. I had already tapped all the mounting screw holes to make sure they were clean. My screws did not protrude below the piezo top piece. My mounting bracket is flat, but maybe there is some materialby knabo - General
So I am on my third printer using the orion module. This is the first time I am using the screw mount version. My issue on this one is that the probe is difficult to trigger vertically. It triggers easily tapping the side, or moving the hot end. But when I use the bed it pushed up the hotend before it triggers. Hypercube printer with a Duet Wifi.by knabo - General
When I first mounted the Orion kit, I used some small washers so there was no preload on the sensor. This was for no particular reason other than I didn't know what I was doing. After I was told about the preload I removed the washers and reassembled the kit. I ran some M48 repeatability tests before and after, with motion and without motion. I attached the data. While the preload did imprby knabo - General
I just got my orion kit (order 10773) and I had some questions about the mounting of the PCB. First the clamp on the E3D V6 was too tight. I tried to screw it together but there was too much gap to make up and I was worried I would break the part. When I put the screw in and tightened it there was twice as much gap on the front than the back. Ultimately I had to remove some material from insiby knabo - General