I appreciate the recommendations. It sounds like the Duet 8.5 is highly recommended. I do have a few questions about this board. where is the best place to purchase it in the US? is it possible to wire 6 endstop switches (2 for each axis)? It would be fine if the min and max are wired to the same input (so long as this does not cause a firmware issue). Basicly i am concerned that without an enby bdeuell - Controllers
Hello, I am working on a design for a 3D printer. The mechanics will be a custom design but I want to use off the shelf electronics. Right now I have narrowed my choice down to the ultimaker 2 board or the RAMBo 1.3 (links below). I am looking for a recommendation on the best board to use RAMBo UM2 motherboard Below are the requirements i have: community support, there is a great community arby bdeuell - Controllers