I'm about to wire an SKR 1.3 myself. The original board had 2 power hookups, with the second set listed as heated bed power. Now I have 2 sets of wires coming from the PSU and only one set of termials. I presume the 2 fuses indicate separate power circuits for the bed and everything else, but I'm not sure exactly how I should handle the wiring coming out of the PSU. Can I just remove one set compby JangusKhan - Controllers
Ok, if you're still following this thread I've got a new conundrum: I found a set of Configuration.h and Configuration_adv.h files for Marlin 2.0 for the Anycubic Linear Plus. Everything looks good, but the compile fails every time, LPC1768 Failed in the report. I've tried deleting the .pio files but that doesn't help. The same guy provided a .bin file to drop directly onto the SD card, but he'sby JangusKhan - Controllers
Thanks, that was informative. I got home late last night so I've only had a few minutes to look at the board and the documentation. I didn't realize that the collection of red jumper pins were designed to simplify the UART connections. That's great! Now to dig in on firmware installation. Teaching Tech's videos seem pretty informative.by JangusKhan - Controllers
Yeah, that's all good, i'm not trying to make this the ultimate machine, i just want it to print better than the wavy, stuttering crap that it is right now. Honestly, I'm trying to find a decent breakdown of all of the driver modes in a way that isn't comparing one to another. It's taken me a while to get to where I am right now, mostly because of lack of decent explanatory material. Standalone mby JangusKhan - Controllers
I already ordered them, but what's the main difference? I can return them if you make a solid case.by JangusKhan - Controllers
Whoa, that SKR 1.3 is crazy cheap comparatively! Am I reading this right? $24 for the board and $30 more for Trinamic drivers? I've heard that ARM boards have gotten cheaper but damn that looks good. I'll have to brush up on the whole Marlin 2.0, PlatformIO stuff as I'm still living in the Arduino world, but I'm about to hit the order button right now.by JangusKhan - Controllers
All good info. Yeah, I saw that bit about the LCD cable but I didn't realize the reason behind it. Here's the thing though, after buying the ReArm, a suitable RAMPS board, and a set of TMC2209 drivers, I'm sitting at somewhere between $70-90. At that point I might as well just buy a Duet board and be done with it, no?by JangusKhan - Controllers
Ok, that's what I expected in terms of the RAMPS board and stepper drivers. Didn't know about 32 bit Marlin, but it looks pretty straightforward. The machine already has typical stepper driver modules, but the ReArm board from Panucatt has options to add better ones. I suppose the Trinamic based option is a good bet? Also, any suggestions for a reputable source of RAMPS board? I bought one on Amaby JangusKhan - Controllers
Long story short, I need to upgrade the control board in my Anycubic Linear Plus from the original TriGorilla to something with more brain power. That little processor just can't handle all the delta kinematic calculations. I've been 3D printing for a while, but I've never swapped a stock control board for an upgrade before. I'm OK with dealing with firmware, but I'm discovering there are more faby JangusKhan - Controllers