Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
Hi,
Thank you very much for the reply.
I have tried 1.09r but encountered exactly the same symptom and I did use the command "T0" then "M302 P1" before activating the extruder motor every time.
Can it be the heater sensor issue?
I got error message "Temperature fault on heater 1, sensor circuit is open/disconnected, T = -273.1"
I checked the wiring and found the blue wire (blue & green fo
by
Queenayayi
-
Firmware - mainstream and related support
Hi everyone,
I bought a Ormerod 2 (528.3) with Duet 0.6 last December (2015) and the extruder motor never really worked.
It only turned slightly at the beginning during the commissioning/calibration steps and then nothing happened until I restarted the whole machine. And then again, it only turned for less than a second.
I have connected the extruder motor to X motor pins on the PCBA and it r
by
Queenayayi
-
Firmware - mainstream and related support