Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 3 of 3
On my printer (Arduino Mega2560 clone, RAMPS 1.4, Teacup firmware), the fan started working after I added
DEFINE_HEATER(fan, PH6, 1)
into config.h
The fan is connected to D9, controlled by M106 P2 Sxxx.
by
fix_it_alex
-
Firmware - experimental, borrowed, and future
Hi Traumflug,
On my board i uploaded the bootloader, but i cannot upload anything using it. Neither the firmware nor SetupTest.ino. The board passes the Zoman's test with looped RX-TX. When uploading from the Arduino IDE, the left green LED blinks every 8-10 sec, the MCP2200 configuration utility recognizes the chip, but the Arduino IDE does not see it. Where can i find the compiled file of the T
by
fix_it_alex
-
Next Wave Electronics Working Group