Show all posts by user
Page 1 of 1 Pages: 1
Results 1 — 8 of 8
cool
does the servo motors is a absolute necessity ? I've some steppers boring on a shelf...
by
cdriko
-
Hangprinter
Hello. it's a great machine !
is it possible to minimise the nacel dimension?
wath is the minimum size of temporary frame.. because I'm planing to built one with frame.
by
cdriko
-
Hangprinter
hello
I'va a question about config.h
DEFINE_TEMP_SENSOR(extruder, TT_INTERCOM, 0, 255)
my thermistor is connected to Analog pin 1, closed loop with heater defined on
#define DEFINE_HEATER(extruder, PORTD, PIND6, OCR0A)
I've try both :
#define DEFINE_TEMP_SENSOR(extruder,TT_THERMISTOR,AI01,0)
and
#define DEFINE_TEMP_SENSOR(extruder,TT_THERMISTOR,1,0)
I allays get an error c
by
cdriko
-
Firmware - experimental, borrowed, and future
Hi Triffid
thanks a lot.
In the arduino console : no responses, but
with your method : ok
here somme conversation :
Start
ok
G1 X4
ok
M114
ed checksum ok
M115
E: Bad M-code 115
ok
M105
T: 0.0
ok
GO X7
ok
G1 Z4
ok
by
cdriko
-
Firmware - experimental, borrowed, and future
Quotespaztik
Is the position returned by the m114 command in number of steps? If so, is this correct or should it return position in mm or inches depending on which units you are using?
I don't have any return with talking to the arduino via the serail console
even setting the XONXOFF
by
cdriko
-
Firmware - experimental, borrowed, and future
Hello
as I said before, i'm working a reprap
- steppers motors drivers V1
- extruder stepper
- without endstops
- arduino 328
I success to connect to it with the ReplicatorG-5Dsupport of ErikDeBruijn
with little modifications :
- in serial.c
#define BUFSIZE 64
(to corresponds to RepRap5DDriver.java)
- in mendel.c
serial_writestr_P(PSTR("start\nok\n"));
(instead "Start" t
by
cdriko
-
Firmware - experimental, borrowed, and future
Hello
I'm trying to use FiveD for Arduino with an repstrap with arduino
- steppers motors drivers V1
- extruder stepper
- without endstops
under Ubuntu Lucid
I modify the code in config.h and dda.c to avoid endstops
but :
1 - I can't compile under arduino 0018 (or more recent) because can't find "sys/time.h"
2- So I compile it with succes with avrdude BUT
replicatorg0013 say everytime 'm
by
cdriko
-
Firmware - experimental, borrowed, and future
Hello
I'm trying to use replicatorG to drive a homemade repstrap,
using replicatorG (version 0013 to 0019) under ubuntu lucid 32bit.
At start of the program, the machine appears as connected :
[10:35:38] Loading machine: Repstrap_PING
[10:35:38] Loading simulator.
[10:35:38] Loading driver: replicatorg.drivers.SerialPassthroughDriver
[10:35:38] Initializing Serial.
[10:35:40] start
[10:35:40] Re
by
cdriko
-
Controllers