After hours of faffing around, changing every detail I could, the printer eventually connected after I changed the com port to 115 rather than the old setting of 250. Firk, ding and blast.by Denial - General Mendel Topics
The issue is that it won't. Have a legacy mendel from reprappro I finally decided to get round to updating the firmware for. Followed the steps on the reprappro documentation. Uploaded the firmware from the Github fine with no error messages. Then I try connecting to the printer through pronterface. Nothing happens for a minute and then æ|| appears, which then repeats every ten or twenty seconby Denial - General Mendel Topics
Starting to commission my reprappro mendel and long story short the hot end fan isn't spinning. I'm sure i've snipped the right wire and attached the other two up correctly. Voltmeter is showing +12V running through the fan wires and the blue LED light is coming on. But it still won't spin. Given a flick a few times and it spins for a moment then stops dead. The centre motor is heating up asby Denial - General Mendel Topics