HI All, I have been plagued by the Air printing problem, from what I see this is a common problem with no clear solution. I have had my Prusa i3 for a few months and its been nothing less than great. I was very happy with my 3d printer until the Air printing started. Info : Prusa i3 > All metal Hotend > 0.4 mm Nozzle > PLA The first spool of PLA I used (Clear RED) worked perfectlyby KG1610 - General Mendel Topics
was on the IRC > was asked for this.by KG1610 - General Mendel Topics
Downloaded Arduino 0023 > could not open the .DMG > " not recognised " I have done enough searching for one man > its going to cost me but i dont see any other way to proceed. > Looks like i am going to need a new Arduino Mega 2560by KG1610 - General Mendel Topics
Hey all just posting my solution > I remapped the pins from the Y Axiz to E2by KG1610 - General Mendel Topics
Hi Romel, i am using Arduino 1.0.5 Marlin for the Firmware i am downloading Arduino 0023 and will post an update.by KG1610 - General Mendel Topics
Hey Romel, Exact same thermostat as the previous one, from the original supplier. Instead of using my mac - i have loaded Arduino and Repieter Host on my windows machine. same error when connecting via Arduino - if i try upload my Sketch Repieter host can see my printer but "commands just sit and wait" I can control my printer through the LCD interface. any thoughts for troubleshootby KG1610 - General Mendel Topics
Hey All, Hope you can help - i cannot connect to my printer avrdude: stk500v2_ReceiveMessage(): timeout i have built a Prusa i3 > Arduino Mega 2560 + Ramps V1.4 printing fine > life was great .... i had to replace the hotend thermostat and at the same time decided to take the printer apart and polish the frame etc. .. make it more rad. got the new thermistor - finished assembly - now iby KG1610 - General Mendel Topics
ok so rechecked all the wiring and connectors > all ok i plugged the y axis motor (the one shuddering and moving in random) into the x axis plug on the ramps board. - > Y axis motor works perfectly. so could it be the ramps board ? and how can i test / trouble shoot ?by KG1610 - General Mendel Topics
Hey All, I decided to build a PRUSA i3 as a novice to both mechanical and electrical > the build went very well. I am also very amped to print. I am stuck - I'm looking for knowledgeable people to provide a Troubleshooting list I can run through . ISSUE > My Motors are "shuddering" and making sounds no 3d Printer should make Too little or too much current ? - i have changed the cuby KG1610 - General Mendel Topics