I got everything to work as needed and I have full control and even did a dry run last night! very exciting!! your help was invaluable, I had to invert my end-stops to open instead of triggered and everything was perfect and no more issues. I have one last question, and maybe it is also a simple answer: The temp keeps swinging up and down and not averaging out, and the print wont start until iby Andreasv007 - General Mendel Topics
3DKarma, Thank you VERY MUCH for leading me to that firmware. It made all the difference in the world!!!! I am now running into a problem of my Z-axis now moving past my limit switch at the bottom as if it doesn't realize its there. I've checked with a multimeter to see if it functions properly and its hooked up appropriately. possibly a height setting in config.h? I think after that I am goby Andreasv007 - General Mendel Topics
Where are you purchasing your filament from, and how sure are you of its quality? could be really poor grade material causing it to jam. Is this a recent issue or have you always dealt with this?by Andreasv007 - General Mendel Topics
Well I got the board to work and has fluid motion on all axis, and I am trying to calibrate the steps/mm for the x-axis and it stops at 160mm and wont go any further. I have attached a picture and have adjusted my settings in config.h to no help. Is there a dimension I should be setting it to enable it to travel further? here is my mechanical settings as of now: //============================by Andreasv007 - General Mendel Topics
3dkarma I realized this and have adjusted it, I have selected Mendel2 or should it be Mendel? I have been going over it again and again and seems I have a correct config. h, I will post it when I return home from work TommyF, I have only gotten it to home x, and nothing else, movement seems fluid but I don't want to print until I can get everything to home and calibrate at least even basicallby Andreasv007 - General Mendel Topics
Hello RepRap community, I am new to 3d printing, and have been stuck for a few days troubleshooting and calibrating this printer. I am stuck as I am trying to calibrate it, but I am just getting the same steps per mm measurement everytime I adjust the settings in configuration.h I have a Prusa I3 Nema 17 motors 17 tooth pulley gt2 belt Melzi board version 1.1 1/16 stepping m5 Leadscrew I havby Andreasv007 - General Mendel Topics