try M503. It will list your config. Maybe / probably the version is in...by [email protected] - General Mendel Topics
Hi printjunkie, 500/0 degrees means currently 500 degrees, target =0 (not set). Is this centigrade or Fahrenheit? I assume the last one, otherwise you should have a MAXTEMP error. Can you set the target extruder temp via the lcd? or does it return to zero again? regards,by [email protected] - General Mendel Topics
Hello all, I hope someone can help me with mij problem. Of course i googled a lot to find out but there is barely any info available about lsee 3d v1.0 board. I probably burnt the T0 port, probably because the 12 V cable of the extruder heater is broken and i assume it came in contact with the thermistor leads... The result now is that i have a mintemp error on the LCD display. I simuated the tby [email protected] - General Mendel Topics