ok so ive got myself the marlin firmware and im wondering if it will work on my GT2560 board, it uses the same mega 2560 chip and it says its based on a ramps board so in the code do i define the board as a ramps 14 efb or can i set a custom definition for the gt2560? really need a hand with this if anyone could jump on skype and give me a hand that would be awesomeby 23chaos23 - General Mendel Topics
thats a good point, ill give this a go anyway and if i run into the same issue i can look at using higher quality servo or switch altogether to some other sensor type, im using a 300x300 glass bed with a PEI sheet from lolzbot. so if the PEI sheet wont fork with certain sensors i can mount conductive sensors around the skirt of the heat bed, i have about a 20mm perimeter of the heating PCB aroundby 23chaos23 - General Mendel Topics
thanks, ive already built a servo mount with a endstop on the end of the arm. ill give it a go and ask if i run into any issuesby 23chaos23 - General Mendel Topics
hello all, just wondering if this thread is alive and if so i could use some advice on setting this up on my printer, this is the first time ive done this sort of thing and as such im just reaching out for help to avoid costly mistakes. my printer is a fully DIY design built with Open builds frame work. using 2 Nema 23s for Z and 17s for X,Y and the 2 extruders (Geeetech MK8 dual extruder) allby 23chaos23 - General Mendel Topics