correct, for instance here is my G29 T, how do I read this? Bed Topography Report: ( -124,124) (124,124) 0 1 2 3 4 5 6 7 8 9 9 | . . . . +0.314 +0.549 . . . . | 8 | . . -0.073 +0.125 +0.385 +0.675 +0.962by majorkuso - Delta Machines
that is exactly what it was, thanks, are there any good guides on tuning a delta, for instance if one side is too high do I increase or decrease the radius?by majorkuso - Printing
Thanks I am trying to get my k280 tuned is there a good guide on this process if the outer edges are too far how do you adjust?by majorkuso - Delta Machines
I am printing an xyz calibration cube on my k280 delta, but it prints the Y on the left of the x and the on top as expected. When I print the same cube on my Anet E10 it comes out correct with the y on the right and on front, if I compare the two the delta one has to be flipped with the z on the bottom to get it to match the Anet Print. Any,ideas? I used Cura 4.3.0 for both. I have attached a phoby majorkuso - Printing
How do you go about adjusting step 6?by majorkuso - Delta Machines