Ok guys, After about a week or two of playing with settings (switched to the marlin firmware) I can home and run "dry prints" but I have run into a problem. Whenever the end effector moves from x-50 to x50, instead of being level the whole end moves in a bowl shape. Could this be a problem with the diagonal rods possibly not being the same length or a setting in marlin? For example if the end effby Area52 - Delta Machines
SOLVED, Switch jumper pins to 1/16th stepping. Homing works flawlessly now.by Area52 - Delta Machines
Ok, so I installed the jumpers on the ramps board for 1/8 step. The motors behave just like they should now but whenever I home once they get near the limit switches they spazz out again. Only this time less violently than before.by Area52 - Delta Machines
Im using the mechanical endstops. I think its the jumpers considering i dont have any on the board at the moment and the motors act so random.by Area52 - Delta Machines
I think you might be on to something considering I knew nothing of the jumpers lol. Will fix when I get home!by Area52 - Delta Machines
Ok guys, I dove head first into the printer scene and now im really paying for it. I have a classic rostock printer. Got all my guts from Sainsmart. Ramps 1.4 and the Sainsmart A4988 drivers. Firmware is Repetier and am using Repetier host. My problem is when I send g28, the printer spazz's out. It is violent and random. I have adjusted the trim pots on the drivers and have tried every combinatiby Area52 - Delta Machines
Ok guys, I dove head first into the printer scene and now im really paying for it. I have a classic rostock printer. Got all my guts from Sainsmart. Ramps 1.4 and the Sainsmart A4988 drivers. Firmware is Repetier and am using Repetier host. My problem is when I send g28, the printer spazz's out. It is violent and random. I have adjusted the trim pots on the drivers and have tried every combinatiby Area52 - Controllers