I fixed the issue but I don't know what caused the error. I reset the settings for the print bed and it seemed to work. The problem was that pronterface was giving these large bounds of where the part was expected to printby Neosolon - Printrun/Pronterface
When I load the attached STL file to slicer to get the g-code and then load the resulting Gcode to Pronterface I get the following message: the print goes from 228.110000 mm to 271.880000 mm in X and is 43.770000 mm wide the print goes from 78.130000 mm to 121.860000 mm in Y and is 43.730000 mm wide However the print is only 10mm wide. Anyone know why pronterface is causing this error?by Neosolon - Printrun/Pronterface
Anyone know where I can find USB drivers for the Duet board? I'm getting an error message of the USB not being recognized and wanted to try resetting the drivers just in case. Thanks!by Neosolon - Delta Machines
They will be shipping it tomorrow so it may take a week for it to arrive. I could work on some other parts of the project but having the x-axis working for debugging would be nice. If anything it would be just a neat thing to have handy.by Neosolon - Delta Machines
Tony, I sent an email to the T3P3 staff with the order information. In the meantime, is there a way to trick the duet into thinking one of the extruder ports is the X axis by changing the set-up code?by Neosolon - Delta Machines
Hi Tony, Here are in the lines of the config file I'm using. M83 ; ...but relative extruder moves M906 X800 Y1000 Z800 E800 ; Set motor currents (mA) ;M305 P0 R4700 ; Set the heated bedby Neosolon - Delta Machines
The X axis terminals from my Duet board does not seem to be sending the correct signals to the motor. I tried plugging in the same motor to the Y axis terminals and it worked fine so its definitely a problem with the connections or the driver chip but I do not know how to test either problem.by Neosolon - Delta Machines