I have been having the issue that when my bed reaches temperature, and the print starts, the bed will the drop around 10 degrees. I have been printing at 115 and the bed will drop down to around 105. I am using slic3r to create the G-Code, and I have the temperature the same for the first layer and other layers. Any input would be appreciatedby freeflykid - Delta Machines
Thats Paul for the information. I will take a look, I am gone for the weekend so I won't be able to try anything until tomorrow or Monday.by freeflykid - Delta Machines
Yea I am currently using Pronterface & Marlin. I will try that. Where can I get the Repetier Firmware. Is it much different than using Marlin?by freeflykid - Delta Machines
thanks Nutz & Paul_delta.I am using the original power supply from Folgertech. I did try another print using an SD card, and that print ran fine. It was a different file, but similar. I am going to do a few more test runs tomorrow just using the SD card to see if it continues to run smooth. I will also try to lower the speed for the port settings, and see if It will run from my computer. Ifby freeflykid - Delta Machines
Thank you. Just since I am new to all of this, the polyfuses are the wires going into the hot end? I had to put a few piece of tape on the rectangle of the hot end because the fan wasn't allowing the hot end to get hot enough to bring. I put a few layers on and it allowed it to get up to 230 to print. any other suggestions for this.by freeflykid - Delta Machines
hello everyone. I have been reading through the forum to help with my kossel build, and get set up, thank you all, the forum has been a great help. I finally got my printer calibrated after fixing some wiring, and replacing a thermocouple that broke during the build. Last night I printer with ABS, and just printer a small cube I downloaded from thingaverse. I used the sample abs they gave me whiby freeflykid - Delta Machines