just noticed that the "sd fail" is gone after I unchecked the box. now there is a "D init fail" message. any ideas?by cft1234 - Delta Machines
to troubleshoot i switched the thermsistor with the one for the bed and the error went away. when i built the kit i soldered and extension that came in the kit that had a connector on it to the wires coming from the extruder thermisistor. was that wrong? or perhaps it is damage case it was in the correct slot. i also tried just turning the connector 180 but that didn't fix it. even when i usedby cft1234 - Delta Machines
thanks ill check that tonightby cft1234 - Delta Machines
this is the error i get in repetier when i connect and now i cant home. 18:17:03.051 : Printer reset detected - initalizing 18:17:03.051 : start 18:17:03.051 : echo:Marlin 1.0.0 18:17:03.051 : echo: Last Updated: Jan 19 2016 18:13:37 | Author: (FOLGER TECH, KosselRev 18:17:03.051 : Compiled: Jan 19 2016 18:17:03.051 : echo: Free Memory: 3849 PlannerBufferBytes: 1232 18:17:03.051 : echo:Hardcodeby cft1234 - Delta Machines
I got my our Kossel built but I am new to arduino and somewhat new to 3d printing. I got the aduino ide and the rev b firmware and was able to upload it. I then found a video that said I needed to make sure setting for inverting the axis was set to false for xy and z so that it would home in the right dir. and I also slowed to the speed it moved. I was then able to get the printer to home but aftby cft1234 - Delta Machines
I was wondering if when you upload a new sketch to the arduino if everything from the sketch that's on it gets removed. or is it added to?by cft1234 - Delta Machines
I got my our Kossel built but I am new to arduino and somewhat new to 3d printing. I got the aduino ide and the rev b firmware and was able to upload it. I then found a video that said I needed to make sure setting for inverting the axis was set to false for xy and z so that it would home in the right dir. and I also slowed to the speed it moved. I was then able to get the printer to home but aftby cft1234 - Reprappers