Hello, Sorry for the long absence. I have attached my custom config files here. Since it was a couple of years since I had the printer working, I cant guarantee that the settings are correct. But hopefully it will help someone. I am in the process of updating to the newest Marlin, and a lot of settings have changed. These files worked with MARLIN 2.0.x Configurations-release-2.0.6.by RostockDude - Delta Machines
Hi! I have had my Rostock MAX V2 Delta printer upgraded with a BigTreeTech SKR 1.4 Turbo. All worked fine until I accidentally broke my hotend thermistor. I since then bought new thermistors from Amazon and have been trying to get it to work. The thermistors I´ve bought are these: To be honest, I didn´t know exactly if these were the best ones, but I figured 100K thermistor should work? Anyby RostockDude - Firmware - Marlin
Thank you kindly dear thehankinator! I´ve gotten my old printer to work again with a new 32-bit mainboard. This makes me immensly happy! Just a little support and helping attitude gave me the extra energy to keep pushing. It all works fine now! I just have to calibrate everything in finner detail now! All the best!by RostockDude - Delta Machines
You were indeed correct! This is progress. The endstop sensors where connected in the wrong order. I can now home the printer and will try G33 command. Thank you for your continued support!by RostockDude - Delta Machines
I tried changing the homing rate to a really low value to see whats going on. I set it to: #define HOMING_FEEDRATE_Z (10*60) I can see that all endstop triggers are working using M119 command and holding the endstop switch down. This worked for X, Y and Z, illustrating only x_max below. SENT: M119 READ: Reporting endstop status READ: x_max: TRIGGERED READ: y_max: open READ: z_max: open Theby RostockDude - Delta Machines
Hell oagain, I Itried the Radius value of 169.78 and it still was kind of weird. I also tried very high values and low values to see if the problem got better or worse. I still couldn´t understand if the value was too high or too low. I even tried values as low as 130 and as high as 200. I´m starting to suspect that there might be something else that is off aswell. I found one error that I corby RostockDude - Delta Machines
Thank you kindly for your assistance! I will try this a soon as possible and report back. I also have recently learned that it is possible to temporarily change the radius with M665 R where X in my case would be 169.78 in this trial. This might help someone in a similar situation as me. This would possibly speed up the trial and error part of this since I don´t have to rebuild the whole firmwaby RostockDude - Delta Machines
Thank you for your reply and assitance! I read in a lot of places about a G33 auto-calibration process in Marlin. Itried sending the command G33 in the serial monitor promt but got a syntax error message back. I dind´t dare to continue down that path until I knew what was wrong with the movement. Because if I try to move the effector up or down,,, the movement is so "skewed" that the effectorby RostockDude - Delta Machines
Hello, I have a Rostock Max v2 that have worked ok for many years. One day I decided to upgrade the original 8-bit mainboard to a 32-bit Bigtreetech SKR v1.4 Turbo. All the main mechanics are still the same as the Rostock MAX v2 original. I have tried to follow the guidance given in the Marlin firmware files (configuration.h) to use a generic delta profile from the Marlin 2.0.x library and modby RostockDude - Delta Machines