Hard to tell without photos. The mdf bed had a cutout underneath so that it rides over the top of the motor bracket, you do have the bed on the right way around? And you have not tightened the springs down so tight it cant get over the top? I have since changed my controller board to one with tmc2209s and use sensorless homing but never had an issue with the old setup.by Elminster - Huxley
Do you mean 2014? Any way the Y axis micro switch goes on the rear of the Huxley between the Y motor and one of the rods. It will be near the rod that has the Y carriage that has two (rather than one) bearings. When the Bed goes back the rear most bearing on the Y carriage will hit the microswitch causing an endstop. You can see the position of the Y end stop in the 'Y end stop instructions' heby Elminster - Huxley