Hello everyone, i need help with calibrating with my first repstrap. I have followed all the steps/wikis and blogs i found but it seem the box is kinda out of scale(?). As you can see i used a 20x20mm calibration box and the printed box seem to be even smaller than 1cm (The 10x10mm is the boundaries of the print). My question is should i fix the scaling in the firmware?(and how) Or i should nextby staberas - RAMPS Electronics
Γεια σε ολους, βλέπω πολλους εδω οτι φτιαχνετε rep rap αλλα κανεις δεν εχει κανει rep strap (περίεργο μιας και οι τσεπες μας ειναι αδειες αυτες τι μέρες ) Σας παρουσιάζω το rep strap μου πρόκειται για ενα Frankenstein σχεδιαστικά απο prusa i3 φτιαγμένο απο ξύλο, wolfstrap βάση και Ramps 1.3 . Σε αυτή την στιγμή ειμαι στην φάση δοκιμών και τροποποίηση του teacup firmware (οποιος εχει εμπειρίαby staberas - Greek RepRap User Group, ελληνική ομάδα χρηστών
No really, actually Marlin is the only thing i managed to upload since anything else end up with really long compile errors.. (even using the arduino 0022). Also can you point me to some example codes?by staberas - RAMPS Electronics
Hi I'm new on the RAMPS and i have some problems, I have a RAMPS 1.3 (kit) I soldered everything correctly and double checked it. I installed Marlin 1.0.0 RC2. 1st : The led wont light even if its powered (checked the polarity i soldered it correctly) 2nd: Pronterface wont connect when i have Ramps attached i followed every instruction i found and nothing seem to make it work (stepper motorby staberas - RAMPS Electronics